Basis Application
Factors affecting on the gasket Areas of application

Application
General purpose grade suitable for low pressure steam,
water, oils, fuels and inert gases for low stress conditions

Dimensions of the standard sheets :
1500 X4000 mm, 1500 X2000 mm, 1300 X3900 mm, 1270 X1270 mm, 2100 X 3000 mm, 1500 X 3000 mm.
ASTM F 104 Line Call out : F 712232 E34 A9 B6 M4
Test                        Specified           Unit
method                     Value
Max. Peak Temperature                                                      200                 °C
Max. Operating Temperature                                             150                  °C
Max. Operating Pressure                                                      50                  bar
Density                                              ASTM F 1315             1.6 – 1.9           g/cm³
Compressibility                                ASTMF36 J                 7 -17                %
Recovery                                           ASTM F 36J                 ≥ 40               %
Tensile Strength                               ASTM F 152                   ≥ 7              N/mm²
Creep Relaxation                             ASTM F 38B                 ≤40               %
Stress Relaxation (16h 175° C)       DIN52913                      ≥ 15
Gas Sealability                                  ASTM F 37 B                < 1.0           ml/ hour.
ASTM oil no.3 (5h, 150°C)               ASTM F 146
Thickness Increase                                                                  ≤ 15                %
Weight Increase                                                                       ≤ 20               %
ASTM Fuel B (5h, 23°C)                  ASTM F 146
Thickness Increase                                                                  ≤ 20               %
Weight Increase                                                                       ≤ 20               %
Water (5h, 100°C)                            ASTM F 146
Thickness Increase                                                                  ≤ 10                %
Weight Increase                                                                       ≤ 15                 %
All information and recommendations given in this brochure are correct to the best of our knowledge .
However , in view of the wide variety of possible installation and operating conditions one cannot draw the final
conclusion in all application cases regarding the behavior in a gasket joint . Therefore , information can only serve as a guideline.
Superlite® SUPERLITE ASBESTOS FREE GP-150
Gasket material based on organic fibre with
NBR binder.
General purpose grade suitable for low pressure steam,
water, oils, fuels and inert gases for low stress conditions.
The suitability of a gasket material for an
application is dependent upon a multiplicity of
factors as shown in the above digram. Max.
temperature and pressure values can not define
the suitability for application. It is always
advisable to consider these factors when
selecting a material for a given application.
This area refer , the gasket material is normally suitable
subject to chemical compatibility.
This area refer, the gasket material may be suitable but a
technical support is recommended.
This area refer, do not install the gasket without technical
evaluation.
Standard sheet sizes :1500 X1500 mm,1500 X2250mm, 1500 X4500 mm ,1500 X1000 mm,1000X1000mm
Technical data
All data are typical values and refer to sheet thickness of 2.0 mm